Eaton easy800

12 Appendix
12.9 Contacts and Coils
376 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
Enable
PW X EN - X = 01, 02
Fault: Minimum on/off time exceeded - PW X E1/PW X E1
Synchronize clock via NET (Set clock) 241
Trigger
SC X T_ SC X T_ X = 01
Trigger acknowledgement SC X Q1
SC X Q1
SC X Q1/SC X Q1
Serial protocol, send data via serial interface
243
Enable
SP X EN SP X EN X = 01–32
Trigger SP X T_ SP X T_
Send job active
SP X AC
SP X AC
SP X AC/SP X AC
Group fault output
SP X E1
SP X E1
SP X E1/SP X E1
Shift register
247
Enable
SR X EN - X = 01–32
Shift register - SR X Q1-8/SR X Q1-8
Set cycle time
253
Enable
ST X EN - X = 01
Timing relay 255
Enable
T X EN - X = 01-32
Timing relay reset T X RE
Timing relay Stop
T X ST
Timing Relay-Switching contact
- T X Q1/T X Q1
Table function
264
Enable
TB X EN - X = 01-32
Table empty - TB X TE/TB X TE
Table full
TB X TF/TB X TF
Value limitation
268
Enable
VC X EN - X = 01–32
Contact Coil
(* = NET-ID 1-8)
Contact
N/O - N/C
(* = NET-ID 1-8)
Number Page