Eaton easy800

2 Installation
2.7 NET network
54 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
Figure 55:Example of loop-through wiring of easy800 standard
a First station on the easyNet
b Bus termination resistor
c Last station on the EasyNET network
Physical location, place
Station number
Further information on configuring and commissioning the easyNet
￫ Chapter 6‚ “The network Net“, Page 273. Specifications for the
easyNet are provided in the Technical Data, Page 359.
Pin assignment of the RJ45 socket on the device
The networkable devices are provided with two RJ45 sockets.
1
1
2
2
I 1 - 12
12
12
12
12
Q 1 - 8
I 1 - 12
Q 1 - 6
3
3
AS-Interface
+
–
I 1 - 12
Q 1 - 6
8
8
I 1 - 12
Q 1 - 8
R 1 - 12
S 1 - 6
R 1 - 12
S 1 - 8



