3 Commissioning
3.8 The first circuit diagram
80 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
From the first contact to the output coil
With easy800 devices wire from the input to the output. The first input
contact is I01.
▶ Press OK.
easy800 proposes the first contact I01 at the cursor position.
I flashes and can be changed, for example, to a P for a pushbutton input
using the cursor buttons Í or Ú. However, nothing needs to be changed at
this point.
▶ Press OK twice, to move the cursor across the 01 to the second contact
field.
You could also move the cursor to the next contact field using the cursor
button.
▶ Press OK.
Again, inserts easy800 a contact I01 at the cursor position.
▶ Press OK so that the cursor jumps to the next position and press cursor
button Í or Ú to change the number to 02.
▶ Press OK to move the cursor to the third contact field.
You do not need a third relay contact, so you can now wire the contacts
directly up to the coil field.
Wiring
easy800 device displays a small arrow l in the circuit diagram when creating
the wiring.
Press ALT to activate the wiring arrow cursor and use the cursor buttons
Í Ú
ú í to move it. Pressing ALT once more switches the cursor back to Move
mode.
￫
ALT also has two other functions depending on the cursor
position:
• In the left contact field, you can press ALT to insert a new
empty circuit connection.
• The contact under the cursor can be changed between a
N/O and N/C contact by pressing the ALT button.
To Next Page
Loading...
