3 Commissioning
3.8 The first circuit diagram
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com 81
The wiring arrow works between contacts and relays. When you move the
arrow onto a contact or relay coil, it changes back to the cursor and can be
reactivated if required.
▶ Press ALT to wire the cursor from I02 through to the coil field.
The cursor changes into a flashing wiring arrow and automatically jumps to
the next logical wiring position.
▶ Press the cursor button
í. Contact I02 will be connected up to the coil
field.
▶ Press the cursor button í again.
The cursor will move to the coil field.
▶ Press OK.
The specified coil function
Ä and the output relay Q01 are correct and do not
have to be changed.
Your result will look as follows:
Figure 71:Your first wired and functional circuit diagram
= Visible area
▶ Press ESC to leave the circuit diagram display.
The SAVE menu appears.
Saving
Figure 72:SAVE menu
= Visible area
▶ Confirm with OK.
The circuit diagram is stored.
▶ Press the ESC pushbutton twice to return to the main menu.
￫
You can use DEL to erase a connection at the cursor or arrow
position. Where connections intersect, the vertical connections
are deleted first, then, if you press DEL again, the horizontal
connections are deleted.
To Next Page
Loading...
