Eaton easyE4

6. Function blocks
6.1 Manufacturer function blocks
Parameter set Description Note
server must not be permanently
enabled – please refer to → " Activ-
ation by program ", page 714
Parameter display
+ Call enabled
Constants can be edited on the
device, as can function block para-
meters when using the EDP pro-
gramming language.

Type of information trans-
mission
E-Mail; there are no other options as
of this writing

Recipient assignment
Used to select one of the three pos-
sible recipient groups. Each recipient
group contains all the detailed inform-
ation required in order to send an e-
mail.
1 recipient group; there are no other
options as of this writing
Each recipient group needs to be
set up in the hardware con-
figuration. To do this, click on "Pro-
ject" – select a base device – click
on the "E-Mail" tab. You can then
configure the e-mail server and
one or more e-mail recipients for
each of the three available groups.
Subject
The e-mail's subject

Message text
The text must not exceed 160 char-
acters.
A maximum of 128 operand values
can be transmitted for all alarm func-
tion blocks in the project being used.
Example: The value of analog input
IA01 should be sent in the text:

$IA01$
Simulation possible


Other
Retention
The function block does not recognize retentive data.
 → Section "Setting up the e-mail function", page 740
 → Section "BV - Boolean operation", page 470
 → Section "D - Text display", page 474
 → Section "D - Text display editor", page 484
 → Section "DL - Data logger", page 503
 → Section "JC - Conditional jump", page 516
 → Section "LB - Jump label", page 521
 → Section "MC - Acyclical Modbus TCP request", page 523
 → Section "MR - Master Reset", page 534
 → Section "NC - Numerical converter", page 553
 → Section "ST - Set cycle time", page 559
easyE402/24 MN050009ENEaton.com
469