Eaton Network-MS - Page 103

www.eaton.com
Network
Management Card
(Network-MS)
User Manual
Network Management Card – User Manual 34003991XT_EN/JC Page 103/143
IPMask = “xxx.xxx.xxx.xxx”
(1)
IPGateway = “xxx.xxx.xxx.xxx”
(1)
HostName = “xx..xx”
DomainName = “xx..xx”
IPv6Enable = 0|1 (0=No, 1=Yes)
IPv6AutoConf = 0|1 (0=No, 1=Yes)
(2)
IPv6Address1 = “xx.xx/xxx”
(3)(4)
PrefixLength = xx
(3)
IPv6DefaultGateway [= ]
(3)
PrimaryDNS = “xx..xx”
SecondaryDNS = “xx..xx”
FirmwareUpgrade = 0|1 (0=No, 1=Yes)
Examples #> setNetwork IPAddress=xxx.xxx.xxx.xxx IPMask= xxx.xxx.xxx.xxx
Comments
(1)
: Writing enabled according to “DHCP” status
(2)
: Writing enabled according to “IPv6Enable” status
(3)
: Writing enabled according to “IPv6AutoConf” status
(4)
: The value is a concatenation of IPv6 address 1 and prefix length
6.4.2.3 “getSMTP”
Purpose To read a SMTP setting
Syntax getSMTP [option1] [option2]...
options :
HostName
SmtpPort
Authentication
Login
Password
(1)
Examples #> getSMTP HostName
Comments
(1)
: All characters are replaced with the star character ‘*’ (asterisk).
6.4.2.4 “setSMTP”
Purpose To modify a SMTP setting
Syntax setSMTP [option1=xxxx] [option2=yyyy]...
options :
HostName = “xx..xx”
SmtpPort = xx (Default value: 25) (1..65535)
Authentication = 0|1 (0=No, 1=Yes)
Login = “xx..xx”
(1)
Password = “**..**”
(1)(2)