Installation and Setup WinAQMS Mini DAS User manual 1.0
10
o Dial-up Connection is a dropdown list which allows the user to specify which
dial-up connection to use to make a connection to the DAS.
o Dial on start-up allows the user to tell WinAQMS Mini DAS whether it should
try to establish the dial-up connection automatically. If the Connect button is
used then the WinAQMS Mini DAS client will attempt to connect to the
currently selected server using the specified Dial-up connection even if the
Dial on start-up checkbox is not set.
In Figure 11 there is Local, Ooze Lake and Smokey Hollow servers listed. The Local
DAS uses the loop back address (127.0.0.1) and will be located on the same computer
as the client software. The Ooze Lake logger has an IP address of 192.168.0.1 and the
WinAQMS Mini DAS client software will establish the Hong Kong dialup connection
(using the entered Username, Password and Domain) before attempting to connect to
the logger when the Connect button is pressed. The Smokey Hollow logger with IP
address of 10.0.0.1 will use the Perth VPN dialup connection when connect is
pressed.
The Dial on Startup checkbox is used by WinAQMS Mini DAS to determine if a
dialup connection should be established if it is started and the /ask command line
option is not used. If the Smokey Hollow logger was the last logger connected and
WinAQMS Mini DAS was started without the /ask command line option then the
WinAQMS Mini DAS client would try to connect to the Smokey Hollow logger at IP
address 10.0.0.1 using its currently active dialup/LAN connections. If the Ooze Lake
logger was the last logger connected to and WinAQMS Mini DAS was started
without the /ask command line option then the WinAQMS Mini DAS client would try
to connect to the Ooze Lake logger at IP address 192.168.0.1 by first establishing the
Hong Kong dialup connection.
To Next Page
Loading...