Appendix WinAQMS Mini DAS User manual 1.0
66
We have now added three channels to the TP which record barometric pressure and
wind speed and direction. To vector average the wind speed and direction channels
two calculated channels are needed. On the menu bar select Edit and then select
Calculated Channels. The calculated channels window will load and show an empty
table. Click on the Vector Averaged Channels tab and then add two new channels.
Enter the channel settings as shown in table 7 below.
Table 7 Settings for the vector averaged wind speed and wind direction channels
Click on the OK button at the bottom left corner of the window to save the changes
you have just made and to restart the WinAQMS Mini DAS Server process with the
changes. The vector averaged wind speed and direction channels are now set up and
will begin logging.
Now we will add a Ecotech 9841 oxides of Nitrogen analyser and a 9850 Sulfur
Dioxide analyser. These two analysers will be multi-dropped together with the
Ecotech 9830 carbon monoxide analyser that is already set up on the system.
Open the Analyser Parameters window and click on the Add New Analyser button.
This will add a new analyser to WinAQMS Mini DAS which will be an Ecotech
To Next Page
Loading...