Edit Menu WinAQMS Mini DAS User manual 1.0
40
FTP Address: URL or IP address of FTP server
FTP Username: Username needed to logon to FTP server
FTP Password: Password needed to logon to FTP server
FTP Remote Directory: If data is to be located in subdirectories on FTP server
eg. Data
File Prefix: Attaches character to the start of the filename to
differentiate data from different stations
Connect mode: Choose between “Active” and “Passive”.
Active work by WinAQMS Mini DAS initialising a
connection to the FTP Server, the server then connects
to WinAQMS Mini DAS.
Passive works by WinAQMS Mini DAS initialising a
connection to the FTP Server which informs
WinAQMS Mini DAS of which port to connect to,
WinAQMS Mini DAS will then connect to the FTP
Server on the specified port.
Protocol
Implicit (Secure): The FTP server defines a specific port for the client
(990) to be used for secure connections.
Explicit (Secure): Uses the default ftp port (port 21)
Standard (Not Secure): Standard port 21 with no security
Polling
Transfer Increment (mins): Number of mins between data transfers
Last Transfer: The date of last transfer (this does not need to be set in
initial setup)
Next Transfer: The date of the next transfer (this can be set in initial
setup or can be left)
Last Result: A number indicating the status of the last result. i.e. 0
for success
Write data: Choose either “Append” or “New File”.
Append will create a single file for each day and all
uploads from that day will be stored in this file.
New File will create a new file for every upload
(including the time in the filename) as defined by the
transfer increment value above.
Enabled: This enables/ disables the service to start the Data
Pusher.
To Next Page
Loading...