EDAN X8 - Changing Monitor Settings; Adjusting Screen Brightness; Changing Date and Time; Adjusting Volume

Patient Monitor User Manual Basic Operation
- 22 -
automatically resume the NFC mode.
After exiting NFC mode:
1. The HR physiological alarms are still on and can be set to off by the user.
2. Pause Time keeps no change and the user can set it to Permanent.
3. Prompt information NFC Mode On gets disappeared.
3.4 Changing Monitor Settings
3.4.1 Adjusting Screen Brightness
To change the screen brightness:
1. Select the shortcut key on the screen directly, or
2. Select Menu > Common Function > Brightness, and select the appropriate setting for the
screen brightness. 10 is the brightest, 1 is the least bright.
3.4.2 Changing Date and Time
To change the date and time, please refer to Section Setting Date and Time.
WARNING
Change to date and time will influence the storage of trend data.
3.5 Adjusting Volume
3.5.1 Adjusting Key Volume
The key volume is the volume you hear when you select any field on the monitor screen or when
you turn the knob. To adjust the key volume:
1. Select the shortcut key on the screen directly, or
2. Select Menu > System Setup > Key Volume, then select the appropriate setting for the key
volume: five bars represent the maximum volume and one bar represents the minimum
volume. If none of bars are selected, the key volume will be off.
3.5.2 Adjusting Alarm Volume
To change the alarm volume:
1. Select the shortcut key on the screen directly, or
2. Select Menu > Alarm Setup and select the desired setting for the AlarmVolume item: five
bars represent the maximum volume and one bar represents the minimum volume.