Patient Monitor User Manual Basic Operation
- 24 -
NOTE:
1 If calibration file is lost or damaged, the monitor will automatically enter into screen
calibration interface.
2 In the screen calibration interface, the screen turns gray and no measurement data
can be displayed.
3.10 Disabling the Touch Screen
The user can disable touch screen operation by selecting and holding the permanent key
for three seconds. A message of Screen Locked and the symbol will be displayed at the
bottom of screen. To enable the touch screen operation, select the symbol by using the knob.
3.11 Using the Barcode Scanner
To enter the barcode setup menu, please select Menu > Maintenance > User Maintain. After
entering the required password ABC, select Other Setups > BarCode Setup. Then the user can
set serial No, last Name, first Name and so on.
User can also check relevant scanner device information in User Maintain > Scanner
Management.
If the scanner is connected for the first time, the monitor will pop up a confirmation message to
ask user whether the new USB device is added as scanner. Choose Yes to add as scanner, choose
No to add as USB device. Please refer to chapter Accessories for the recommended scanner.
NOTE:
The start and end code should be set before using scanner to update patient, otherwise
the barcode can’t be recognized normally. After setting start and end code, user should
also set male code and female code to distinguish the gender.
To Next Page
Loading...
