EDAN X8 - Adjustable Range of Alarm Limits

Patient Monitor User Manual Alarm Information
- 48 -
Message
Cause
Recorder Setup Needed
If the monitor is not configured with the recorder function,
it will indicate Recorder Setup Needed after the Record
button is pressed.
No Default Printer
No default printer has been set.
Incomplete parameter input,
unable to score
In MEWS interface, parameters are not completely input.
No WIFI module detected
No Wi-Fi module is detected.
NIBP Simul
NIBP Simul function is turned on.
NFC Mode On
NFC Mode is turned on.
5.4 Adjustable Range of Alarm Limits
ECG alarm limits are listed as follows: unit (bpm)
Patient Type
Adjustable Range
HR
ADU
15~300
PED/ NEO
15~350
ST analysis alarm limits are listed as follows: unit (mV)
Adjustable Range
ST
-2.0~2.0
RESP alarm limits are listed as follows: unit (rpm)
Patient Type
Adjustable Range
ADU
6~120
PED/ NEO
6~150
SpO
2
alarm limits are listed as follows (unit %):
Adjustable Range
SpO
2
20~100
SpO
2
Desat Limits are listed as follows (unit %):
Adjustable Range
SpO
2
Desat Limit
20~99
NOTE:
User can set the range through User Maintain > Alarm Setup > SpO
2
Desat Limit,
SpO
2
Desat Limit should be less than or equal to SpO
2
alarm low limit.