Patient Monitor User Manual User Interface
- 56 -
7.12 Default Configuration
To set default configuration, select Menu > Default. On the Default menu, users can choose a
factory configuration (adult, pediatric or neonate) based on the patient category. Also, users can
choose a user configuration saved in the monitor if it is available. For more information about
user configuration, refer to User Configuration.
To check the configuration currently used, select Menu > Default. The one labeled with ● is
current configuration. If there's no labeled configuration, it means the currently used
configuration is not one of them.
7.13 Neonatal Configuration*
*Only applicable for X10
Neonatal configuration is exclusively designed for neonate. When it is set to On, the patient type
is defaulted to be neonate and cannot be changed.
Neonatal configuration is not set by user. Contact the professionals authorized by the
manufacturer if needed.
To Next Page
