How to Use This Guide
– 5 –
May 2023 Revision
This is the 10th revision of this guide. It is valid for software release v12.4.0 and
includes the following changes:
Added WAN port auto-detection to QR code Onboarding, see “QR Code
Onboarding” on page 26
Added automatic mesh AP configuration, see “Mesh AP Configuration” on
page 29
Removed Mark and Notrack from firewall rules, see “Firewall Rules” on
page 50
Modified Minimum Signal Allowed, see “Physical Radio Settings” on page 64
Added RF Isolation, see “Physical Radio Settings” on page 64
Modified Dynamic VLAN, see “Wireless Networks — Network Settings” on
page 74
Modified HotSpot 2.0 settings, see “Wireless Networks — Network Settings” on
page 74
Added Log Level, see “System Settings” on page 81
Added SNMPv3 User, see “SNMP” on page 92
Modified Diagnostics and added Speed Test, see “Diagnostics” on page 95
January 2023 Revision
This is the ninth revision of this guide. It is valid for software release v12.3.0 and
includes the following changes:
Updated QR code Onboarding, see “QR Code Onboarding” on page 26
Updated wireless status, see “Wireless Status” on page 37
Added support for dynamic PSK, see “Wireless Networks — Security Settings”
on page 69
Updated Hotspot 2.0 settings, see “Wireless Networks — Network Settings” on
page 74
Added CAPWAP Tunnel Interface to Ethernet Settings, see “Ethernet Settings”
on page 45
November 2022 Revision
This is the eighth revision of this guide. It is valid for software release v12.2.0 and
includes the following changes:
To Next Page
Loading...
Need help?
General
