How to Use This Guide
– 6 –
Added Airtime Fairness, see “Physical Radio Settings” on page 64
Modified the value range of BSS Coloring, see “Physical Radio Settings” on
page 64
Modified wireless security default, see “Wireless Networks — Security Settings”
on page 69
Added 802.11v, see “Wireless Networks — Security Settings” on page 69
Added SNMP Trap, see “SNMP” on page 92
Added BLE Scan, see “BLE” on page 94
November 2022 Revision
This is the seventh revision of this guide. It is valid for software release v12.1.0 and
includes the following changes:
Updated SNMP read/write community settings, see “SNMP” on page 92
Added BLE radio Tx Power, see “BLE” on page 94
Added Interference Detection, see “Physical Radio Settings” on page 64
Added zero-touch provisioning information, see “Zero-Touch Provisioning” on
page 19
Modified the default value for Minimum Signal Allowed, see “Physical Radio
Settings” on page 64
Added 160MHz channel bandwidth option, see “Physical Radio Settings” on
page 64
Removed uCentral cloud option from the Setup Wizard.
July 2022 Revision
This is the sixth revision of this guide. It is valid for software release v12.0.0 and
includes
the following changes:
Updated Setup Wizard for uCentral cloud, see “AP Setup Wizard” on page 21
Added Proxy ARP, see “Wireless Networks — Network Settings” on page 74
Added Multicast-to-Unicast Conversion, see “Wireless Networks — General
Settings” on page 68
Added Bandsteering, see “Physical Radio Settings” on page 64
To Next Page
Loading...
Need help?
General
