How to Use This Guide
– 7 –
Added WPA3 Enterprise 192-bit and OWE security, see “Wireless Networks —
Security Settings” on page 69
Added multiple PSK keys, see “Wireless Networks — Security Settings” on
page 69
Added Short Guard Interval (SGI), see “Wireless Networks — Advanced Radio
Settings” on page 77
Added Multicast/Broadcast Rate, see “Physical Radio Settings” on page 64
Added UPnP, see “LAN Settings” on page 48
Added DHCP Snooping, see “DHCP Snooping” on page 59
Added ARP Inspection, see “ARP Inspection” on page 60
Added DHCP Relay, see “DHCP Relay” on page 61
Added IPv6 for Internet access, see “IPv6 Settings” on page 45
Added Hotspot 2.0, see “Wireless Networks — Network Settings” on page 74
Added Device Discovery Tool, see “Device Discovery” on page 96
Added Discovery Agent settings, see “Edgecore Networks Discovery Tool” on
page 88
Added Reset button and LED enable, see “System Settings” on page 81
Added PoE Out setting, see “Ethernet Settings” on page 45
Added caution on firmware upgrades in uCentral mode, see “Upgrading
Firmware” on page 85
April 2022 Revision
This is the fifth revision of this guide. It is valid for software release v11.6.0 and
includes the following changes:
Added Client mode, see “Physical Radio Settings” on page 64
Added Site Survey, see “Wireless Networks — General Settings” on page 68
Added Custom LAN, see “LAN Settings” on page 48
Added WME configuration, see “Physical Radio Settings” on page 64
Added BSS Coloring, see “Physical Radio Settings” on page 64
Added OFDMA, see “Physical Radio Settings” on page 64
To Next Page
Loading...
Need help?
General
