C
HAPTER
34
| ERPS Commands
– 1114 –
This example displays statistics for all configured ERPS rings.
Console#show erps statistics
ERPS statistics for domain r&d :
Interface Local SF Local Clear SF
------------ ---------- --------------
(W) Eth 1/ 1 0 0
SF NR NR-RB FS MS
---------- ---------- ---------- ---------- ----------
Sent 0 62 948 0 0
Received 0 0 0 0 0
Ignored 0 0 0 0 0
EVENT HEALTH
---------- ----------
Sent 0 0
Received 0 0
Ignored 0 0
Interface Local SF Local Clear SF
------------ ---------- --------------
(E) Eth 1/ 3 0 0
SF NR NR-RB FS MS
---------- ---------- ---------- ---------- ----------
Sent 0 62 948 0 0
Received 0 0 0 0 0
Ignored 0 0 0 0 0
EVENT HEALTH
---------- ----------
Sent 0 0
Received 0 0
Ignored 0 0
Console#
WTB Expire The time before the wait-to-block timer expires.
WTR Expire The time before the wait-to-restore timer expires.
Table 131: show erps statistics - detailed display description
Field Description
Interface The direction, and port or trunk which is configured as a ring port.
Local SF A signal fault generated on a link to the local node.
Local Clear SF The number of times a clear command was issued to terminate
protection state entered through a forced switch or manual switch
SF The number of signal fault messages
NR The number of no request messages
NR-RB The number no request - RPL blocked messages
FS The number of forced switch messages
MS The number of manual switch messages
Table 130: show erps domain - detailed display description (Continued)
Field Description
To Next Page
Loading...
Need help?
General
