C
HAPTER
23
| Authentication Commands
PPPoE Intermediate Agent
– 858 –
PPPOE INTERMEDIATE AGENT
This section describes commands used to configure the PPPoE Intermediate
Agent (PPPoE IA) relay parameters required for passing authentication
messages between a client and broadband remote access servers.
pppoe
intermediate-agent
This command enables the PPPoE Intermediate Agent globally on the
switch. Use the no form to disable this feature.
SYNTAX
[no] pppoe intermediate-agent
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† The switch inserts a tag identifying itself as a PPPoE Intermediate Agent
residing between the attached client requesting network access and the
ports connected to broadband remote access servers (BRAS). The
switch extracts access-loop information from the client’s PPPoE Active
Discovery Request, and forwards this information to all trusted ports
Table 83: PPPoE Intermediate Agent Commands
Command Function Mode
pppoe
intermediate-agent
Enables the PPPoE IA globally on the switch GC
pppoe
intermediate-agent
format-type
Sets the access node identifier and generic error
message for the switch
GC
pppoe
intermediate-agent
port-enable
Enables the PPPoE IA on an interface IC
pppoe
intermediate-agent
port-format-type
Sets the circuit-id or remote-id for an interface IC
pppoe
intermediate-agent trust
Sets the trust mode for an interface IC
pppoe
intermediate-agent
vendor-tag strip
Enables the stripping of vendor tags from PPPoE
Discovery packets sent from a PPPoE server
IC
clear pppoe
intermediate-agent
statistics
Clears PPPoE IA statistics PE
show pppoe
intermediate-agent info
Displays PPPoE IA configuration settings PE
show pppoe
intermediate-agent
statistics
Displays PPPoE IA statistics PE
To Next Page
Loading...
Need help?
General
