To Next Page

To Previous Page

HAPTER

| Multicast Filtering

Filtering and Throttling IGMP Groups

– 628 –

Figure 368: Enabling IGMP Filtering and Throttling

CONFIGURING IGMP

FILTER PROFILES

Use the Multicast > IGMP Snooping > Filter (Configure Profile – Add) page

to create an IGMP profile and set its access mode. Then use the (Add

Multicast Group Range) page to configure the multicast groups to filter.

CLI REFERENCES

◆ "IGMP Filtering and Throttling" on page 1215

COMMAND USAGE

Specify a range of multicast groups by entering a start and end IP address;

or specify a single multicast group by entering the same IP address for the

start and end of the range.

PARAMETERS

These parameters are displayed:

Add

◆ Profile ID – Creates an IGMP profile. (Range: 1-4294967295)

◆ Access Mode – Sets the access mode of the profile; either permit or

deny. (Default: Deny)

When the access mode is set to permit, IGMP join reports are

processed when a multicast group falls within the controlled range.

When the access mode is set to deny, IGMP join reports are only

processed when the multicast group is not in the controlled range.

Add Multicast Group Range

◆ Profile ID – Selects an IGMP profile to configure.

◆ Start Multicast IP Address – Specifies the starting address of a

range of multicast groups.

◆ End Multicast IP Address – Specifies the ending address of a range

of multicast groups.

Edge-Core ECS3510-28T User Manual

Questions and Answers: