C
HAPTER
38
| Multicast Filtering Commands
MVR for IPv6
– 1268 –
MVR FOR IPV6
This section describes commands used to configure Multicast VLAN
Registration for IPv6 (MVR6). A single network-wide VLAN can be used to
transmit multicast traffic (such as television channels) across a service
provider’s network. Any multicast traffic entering an MVR VLAN is sent to
all subscribers. This can significantly reduce to processing overhead
required to dynamically monitor and establish the distribution tree for a
normal multicast VLAN. Also note that MVR maintains the user isolation
and data security provided by VLAN segregation by passing only multicast
traffic into other VLANs to which the subscribers belong.
Transmit
Report Number of reports sent out from source port.
Leave Number of leaves sent out from source port.
Received Field header
Report Number of reports received.
Leave Number of leaves received.
Join Success Number of join reports processed successfully.
Filter Drop Number of report/leave messages dropped by IGMP filter.
Source Port Drop Number of report/leave messages dropped by MVR source port.
Others Drop Number of report/leave messages dropped for other reasons.
Table 168: show mvr statistics summary interface mvr vlan - description
Field Description
Table 169: Multicast VLAN Registration for IPv6 Commands
Command Function Mode
mvr6 associated-profile Binds the MVR group addresses specified in a profile to
an MVR domain
GC
mvr6 domain Enables MVR for a specific domain GC
mvr6 profile Maps a range of MVR group addresses to a profile GC
mvr6
proxy-query-interval
Configures the interval at which the receiver port sends
out general queries.
GC
mvr6 proxy-switching Enables MVR proxy switching, where the source port acts
as a host, and the receiver port acts as an MVR router
with querier service enabled
GC
mvr6 robustness-value Configures the expected packet loss, and thereby the
number of times to generate report and group-specific
queries
GC
mvr6 source-port-mode
dynamic
Configures the switch to only forward multicast streams
which the source port has dynamcially joined
GC
mvr6 upstream-source-ip Configures the source IP address assigned to all control
packets sent upstream
GC
mvr6 vlan Specifies the VLAN through which MVR multicast data is
received
GC
To Next Page
Loading...
Need help?
General
