EasyManuals Logo

Edge-Core ECS3510-28T User Manual

Edge-Core ECS3510-28T
1474 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #621 background imageLoading...
Page #621 background image
C
HAPTER
17
| Multicast Filtering
Layer 2 IGMP (Snooping and Query for IPv4)
– 621 –
To show the interface settings for IGMP snooping:
1. Click Multicast, IGMP Snooping, Interface.
2. Select Show VLAN Information from the Action list.
Figure 362: Showing Interface Settings for IGMP Snooping
FILTERING IGMP
QUERY PACKETS AND
MULTICAST DATA
Use the Multicast > IGMP Snooping > Interface (Configure Interface) page
to configure an interface to drop IGMP query packets or multicast data
packets.
CLI REFERENCES
â—† "ip igmp query-drop" on page 1222
â—† "ip multicast-data-drop" on page 1222
PARAMETERS
These parameters are displayed:
◆ Interface – Specifies port or trunk selection.
◆ IGMP Query Drop – Configures an interface to drop any IGMP query
packets received on the specified interface. If this switch is acting as a
Querier, this prevents it from being affected by messages received from
another Querier. (Default: Disabled)
◆ Multicast Data Drop – Configures an interface to stop multicast
services from being forwarded to users attached to the downstream
port; i.e., the interfaces specified by this command. (Default: Disabled)
WEB INTERFACE
To drop IGMP query packets or multicast data packets:
1. Click Multicast, IGMP Snooping, Interface.
2. Select Configure Port or Configure Trunk from the Action List.
3. Enable the required drop functions for any interface.
4. Click Apply.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ECS3510-28T and is the answer not in the manual?

Edge-Core ECS3510-28T Specifications

General IconGeneral
BrandEdge-Core
ModelECS3510-28T
CategoryNetwork Router
LanguageEnglish

Related product manuals