– 793 –
22 REMOTE MONITORING COMMANDS
Remote Monitoring allows a remote device to collect information or
respond to specified events on an independent basis. This switch is an
RMON-capable device which can independently perform a wide range of
tasks, significantly reducing network management traffic. It can
continuously run diagnostics and log information on network performance.
If an event is triggered, it can automatically notify the network
administrator of a failure and provide historical information about the
event. If it cannot connect to the management agent, it will continue to
perform any specified tasks and pass data back to the management station
the next time it is contacted.
This switch supports mini-RMON, which consists of the Statistics, History,
Event and Alarm groups. When RMON is enabled, the system gradually
builds up information about its physical interfaces, storing this information
in the relevant RMON database group. A management agent then
periodically communicates with the switch using the SNMP protocol.
However, if the switch encounters a critical event, it can automatically send
a trap message to the management agent which can then respond to the
event if so configured.
Table 68: RMON Commands
Command Function Mode
rmon alarm Sets threshold bounds for a monitored variable GC
rmon event Creates a response event for an alarm GC
rmon collection history Periodically samples statistics IC
rmon collection rmon1 Enables statistics collection IC
show rmon alarms Shows the settings for all configured alarms PE
show rmon events Shows the settings for all configured events PE
show rmon history Shows the sampling parameters for each entry PE
show rmon statistics Shows the collected statistics PE
To Next Page
Loading...
Need help?
General
