C
HAPTER
20
| System Management Commands
Time
– 749 –
show logging
sendmail
This command displays the settings for the SMTP event handler.
COMMAND MODE
Normal Exec, Privileged Exec
EXAMPLE
Console#show logging sendmail
SMTP servers
-----------------------------------------------
192.168.1.19
SMTP Minimum Severity Level: 7
SMTP destination email addresses
-----------------------------------------------
ted@this-company.com
SMTP Source Email Address: bill@this-company.com
SMTP Status: Enabled
Console#
TIME
The system clock can be dynamically set by polling a set of specified time
servers (NTP or SNTP). Maintaining an accurate time on the switch enables
the system log to record meaningful dates and times for event entries. If
the clock is not set, the switch will only record the time from the factory
default set at the last bootup.
Table 59: Time Commands
Command Function Mode
SNTP Commands
sntp client Accepts time from specified time servers GC
sntp poll Sets the interval at which the client polls for time GC
sntp server Specifies one or more time servers GC
show sntp Shows current SNTP configuration settings NE, PE
NTP Commands
ntp authenticate Enables authentication for NTP traffic GC
ntp authentication-key Configures authentication keys GC
ntp client Enables the NTP client for time updates from specified
servers
GC
ntp server Specifies NTP servers to poll for time updates GC
show ntp Shows current NTP configuration settings NE, PE
Manual Configuration Commands
clock summer-time
(date)
Configures summer time
*
for the switch’s internal
clock
GC
To Next Page
Loading...
Need help?
General
