C
HAPTER
20
| System Management Commands
SMTP Alerts
– 748 –
logging sendmail
destination-email
This command specifies the email recipients of alert messages. Use the no
form to remove a recipient.
SYNTAX
[no] logging sendmail destination-email email-address
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
You can specify up to five recipients for alert messages. However, you must
enter a separate command to specify each recipient.
EXAMPLE
Console(config)#logging sendmail destination-email ted@this-company.com
Console(config)#
logging sendmail
source-email
This command sets the email address used for the “From” field in alert
messages. Use the no form to restore the default value.
SYNTAX
logging sendmail source-email email-address
no logging sendmail source-email
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
You may use an symbolic email address that identifies the switch, or the
address of an administrator responsible for the switch.
EXAMPLE
Console(config)#logging sendmail source-email bill@this-company.com
Console(config)#
To Next Page
Loading...
Need help?
General
