C
HAPTER
4
| Basic Management Tasks
Resetting the System
– 146 –
WEB INTERFACE
To display memory utilization:
1. Click System, then Memory Status.
Figure 24: Displaying Memory Utilization
RESETTING THE SYSTEM
Use the System > Reset menu to restart the switch immediately, at a
specified time, after a specified delay, or at a periodic interval.
CLI REFERENCES
◆ "reload (Privileged Exec)" on page 694
◆ "reload (Global Configuration)" on page 690
◆ "show reload" on page 695
COMMAND USAGE
◆ This command resets the entire system.
◆ When the system is restarted, it will always run the Power-On Self-Test.
It will also retain all configuration information stored in non-volatile
memory by the copy running-config startup-config command (see
"copy" on page 718).
PARAMETERS
The following parameters are displayed:
System Reload Information
◆ Reload Settings – Displays information on the next scheduled reload
and selected reload mode as shown in the following example:
“The switch will be rebooted at March 9 12:00:00 2012. Remaining
Time: 0 days, 2 hours, 46 minutes, 5 seconds.
Reloading switch regularly time: 12:00 everyday.”
◆ Refresh – Refreshes reload information. Changes made through the
console or to system time may need to be refreshed to display the
current settings.
◆ Cancel – Cancels the current settings shown in this field.
To Next Page
Loading...
Need help?
General
