C
HAPTER
20
| System Management Commands
Banner Information
– 698 –
hostname This command specifies or modifies the host name for this device. Use the
no form to restore the default host name.
SYNTAX
hostname name
no hostname
name - The name of this host. (Maximum length: 255 characters)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#hostname RD#1
Console(config)#
BANNER INFORMATION
These commands are used to configure and manage administrative
information about the switch, its exact data center location, details of the
electrical and network circuits that supply the switch, as well as contact
information for the network administrator and system manager. This
information is only available via the CLI and is automatically displayed
before login as soon as a console or telnet connection has been
established.
Table 48: Banner Commands
Command Function Mode
banner configure Configures the banner information that is displayed
before login
GC
banner configure
company
Configures the Company information that is displayed
by banner
GC
banner configure
dc-power-info
Configures the DC Power information that is displayed
by banner
GC
banner configure
department
Configures the Department information that is
displayed by banner
GC
banner configure
equipment-info
Configures the Equipment information that is
displayed by banner
GC
banner configure
equipment-location
Configures the Equipment Location information that is
displayed by banner
GC
banner configure ip-lan Configures the IP and LAN information that is
displayed by banner
GC
banner configure
lp-number
Configures the LP Number information that is
displayed by banner
GC
To Next Page
Loading...
Need help?
General
