C
HAPTER
20
| System Management Commands
Banner Information
– 703 –
EXAMPLE
Console(config)#banner configure equipment-info manufacturer-id ECS3510-28T
floor 3 row 10 rack 15 shelf-rack 12 manufacturer EdgeCore
Console(config)#
banner configure
equipment-location
This command is used to configure the equipment location information
displayed in the banner. Use the no form to restore the default setting.
SYNTAX
banner configure equipment-location location
no banner configure equipment-location
location - The address location of the device.
(Maximum length: 32 characters)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
COMMAND USAGE
Input strings cannot contain spaces. The banner configure equipment-
location command interprets spaces as data input boundaries. The use of
underscores ( _ ) or other unobtrusive non-letter characters is suggested
for situations where white space is necessary for clarity.
EXAMPLE
Console(config)#banner configure equipment-location
710_Network_Path,_Indianapolis
Console(config)#
banner configure
ip-lan
This command is used to configure the device IP address and subnet mask
information displayed in the banner. Use the no form to restore the default
setting.
SYNTAX
banner configure ip-lan ip-mask
no banner configure ip-lan
ip-mask - The IP address and subnet mask of the device.
(Maximum length: 32 characters)
DEFAULT SETTING
None
To Next Page
Loading...
Need help?
General
