C
HAPTER
39
| LLDP Commands
– 1299 –
lldp dot3-tlv
mac-phy
This command configures an LLDP-enabled port to advertise its MAC and
physical layer capabilities. Use the no form to disable this feature.
SYNTAX
[no] lldp dot3-tlv mac-phy
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
This option advertises MAC/PHY configuration/status which includes
information about auto-negotiation support/capabilities, and operational
Multistation Access Unit (MAU) type.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv mac-phy
Console(config-if)#
lldp dot3-tlv
max-frame
This command configures an LLDP-enabled port to advertise its maximum
frame size. Use the no form to disable this feature.
SYNTAX
[no] lldp dot3-tlv max-frame
DEFAULT SETTING
Enabled
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
Refer to "Frame Size" on page 715 for information on configuring the
maximum frame size for this switch.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#lldp dot3-tlv max-frame
Console(config-if)#
To Next Page
Loading...
Need help?
General
