C
ONTENTS
– 18 –
Transmitting Loop Back Messages 534
Transmitting Delay-Measure Requests 536
Displaying Local MEPs 538
Displaying Details for Local MEPs 539
Displaying Local MIPs 541
Displaying Remote MEPs 542
Displaying Details for Remote MEPs 543
Displaying the Link Trace Cache 545
Displaying Fault Notification Settings 546
Displaying Continuity Check Errors 547
OAM Configuration 549
Enabling OAM on Local Ports 549
Displaying Statistics for OAM Messages 551
Displaying the OAM Event Log 552
Displaying the Status of Remote Interfaces 553
Configuring a Remote Loop Back Test 554
Displaying Results of Remote Loop Back Testing 556
15 IP CONFIGURATION 559
Using the Ping Function 559
Using the Trace Route Function 561
Address Resolution Protocol 562
Setting the ARP Timeout 563
Displaying ARP Entries 563
Setting the Switch’s IP Address (IP Version 4) 564
Configuring the IPv4 Default Gateway 564
Configuring IPv4 Interface Settings 565
Setting the Switch’s IP Address (IP Version 6) 568
Configuring the IPv6 Default Gateway 568
Configuring IPv6 Interface Settings 569
Configuring an IPv6 Address 574
Showing IPv6 Addresses 576
Showing the IPv6 Neighbor Cache 578
Showing IPv6 Statistics 579
Showing the MTU for Responding Destinations 585
To Next Page
Loading...
Need help?
General
