C
HAPTER
14
| Basic Administration Protocols
Configuring Event Logging
– 422 –
higher will be sent to the configured email recipients. For example,
using Level 7 will report all events from level 7 to level 0.
(Default: Level 7)
◆ Email Source Address – Sets the email address used for the “From”
field in alert messages. You may use a symbolic email address that
identifies the switch, or the address of an administrator responsible for
the switch.
◆ Email Destination Address – Specifies the email recipients of alert
messages. You can specify up to five recipients.
◆ Server IP Address – Specifies a list of up to three recipient SMTP
servers. IPv4 or IPv6 addresses may be specified. The switch attempts
to connect to the listed servers in sequential order if the first server
fails to respond.
WEB INTERFACE
To configure SMTP alert messages:
1. Click Administration, Log, SMTP.
2. Enable SMTP, specify a source email address, and select the minimum
severity level. Specify the source and destination email addresses, and
one or more SMTP servers.
3. Click Apply.
Figure 232: Configuring SMTP Alert Messages
To Next Page
Loading...
Need help?
General
