C
HAPTER
14
| Basic Administration Protocols
Connectivity Fault Management
– 531 –
COMMAND USAGE
â—† All MEPs that exist on other devices inside a maintenance association
should be statically configured to ensure full connectivity through the
cross-check process.
â—† Remote MEPs can only be configured if local domain service access
points (DSAPs) have already been created (see "Configuring
Maintenance End Points") at the same maintenance level and in the
same MA. DSAPs are MEPs that exist on the edge of the domain, and
act as primary service access points for end-to-end cross-check, loop-
back, and link-trace functions.
â—† The MEP cross-check start delay which sets the maximum delay that a
device waits for remote MEPs to come up before starting the cross-
check operation can be configured on the Configure Global page (see
"Configuring Global Settings for CFM").
â—† SNMP traps for continuity check events discovered by cross-check
operations can also be configured on the Configure Global page (see
"Configuring Global Settings for CFM").
PARAMETERS
These parameters are displayed:
◆ MD Index – Domain index. (Range: 1-65535)
◆ MA Index – MA identifier. (Range: 1-2147483647)
◆ MEP ID – Identifier for a maintenance end point which exists on
another CFM-enabled device within the same MA. (Range: 1-8191)
WEB INTERFACE
To configure a remote maintenance end point:
1. Click Administration, CFM.
2. Select Configure Remote MEP from the Step list.
3. Select Add from the Action list.
4. Select an entry from MD Index and MA Index.
5. Specify the remote MEPs which exist on other devices within the same
MA.
6. Click Apply.
To Next Page
Loading...
Need help?
General
