C
HAPTER
17
| Multicast Filtering
Multicast VLAN Registration for IPv6
– 662 –
â—† The MVR6 group address range assigned to a profile cannot overlap
with the group address range of any other profile.
â—† MRV6 domains can be associated with more than one MVR6 profile. But
since MVR6 domains cannot share the group range, an MRV6 profile
can only be associated with one MVR6 domain.
PARAMETERS
These parameters are displayed:
Configure Profile
◆ Profile Name – The name of a profile containing one or more MVR6
group addresses. (Range: 1-21 characters)
◆ Start IPv6 Address – Starting IP address for an MVR6 multicast
group. This parameter must be a full IPv6 address including the
network prefix and host address bits.
◆ End IPv6 Address – Ending IP address for an MVR6 multicast group.
This parameter must be a full IPv6 address including the network prefix
and host address bits.
Associate Profile
◆ Domain ID – An independent multicast domain. (Range: 1-5)
◆ Profile Name – The name of a profile to be assigned to this domain.
(Range: 1-21 characters)
WEB INTERFACE
To configure an MVR6 group address profile:
1. Click Multicast, MVR6.
2. Select Configure Profile from the Step list.
3. Select Add from the Action list.
4. Enter the name of a group profile to be assigned to one or more
domains, and specify a multicast group that will stream traffic to
participating hosts.
5. Click Apply.
To Next Page
Loading...
Need help?
General
