C
HAPTER
24
| General Security Measures
DHCPv4 Snooping
– 892 –
ip dhcp snooping This command enables DHCP snooping globally. Use the no form to restore
the default setting.
SYNTAX
[no] ip dhcp snooping
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† Network traffic may be disrupted when malicious DHCP messages are
received from an outside source. DHCP snooping is used to filter DHCP
messages received on an unsecure interface from outside the network
or fire wall. When DHCP snooping is enabled globally by this command,
and enabled on a VLAN interface by the ip dhcp snooping vlan
command, DHCP messages received on an untrusted interface (as
specified by the no ip dhcp snooping trust command) from a device not
listed in the DHCP snooping table will be dropped.
â—† When enabled, DHCP messages entering an untrusted interface are
filtered based upon dynamic entries learned via DHCP snooping.
â—† Table entries are only learned for trusted interfaces. Each entry
includes a MAC address, IP address, lease time, VLAN identifier, and
port identifier.
â—† When DHCP snooping is enabled, the rate limit for the number of DHCP
messages that can be processed by the switch is 100 packets per
second. Any DHCP packets in excess of this limit are dropped.
â—† Filtering rules are implemented as follows:
â–
If global DHCP snooping is disabled, all DHCP packets are
forwarded.
â–
If DHCP snooping is enabled globally, and also enabled on the VLAN
where the DHCP packet is received, all DHCP packets are forwarded
for a trusted port. If the received packet is a DHCP ACK message, a
dynamic DHCP snooping entry is also added to the binding table.
ip dhcp snooping database
flash
Writes all dynamically learned snooping entries to
flash memory
PE
show ip dhcp snooping Shows the DHCP snooping configuration settings PE
show ip dhcp snooping
binding
Shows the DHCP snooping binding table entries PE
Table 91: DHCP Snooping Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General
