C
HAPTER
26
| Interface Commands
Interface Configuration
– 980 –
EXAMPLE
Console#show interfaces status ethernet 1/1
Information of Eth 1/1
Basic Information:
Port Type : 100BASE-TX
MAC Address : 00-E0-0C-00-00-FE
Configuration:
Name :
Port Admin : Up
Speed-duplex : Auto
Capabilities : 10half, 10full, 100half, 100full
Broadcast Storm : Enabled
Broadcast Storm Limit : 64 kbits/second
Multicast Storm : Disabled
Multicast Storm Limit : 64 kbits/second
Unknown Unicast Storm : Disabled
Unknown Unicast Storm Limit : 64 kbits/second
Flow Control : Disabled
VLAN Trunking : Disabled
LACP : Disabled
MAC Learning : Enabled
Media Type : Copper forced
Current Status:
Link Status : Up
Port Operation Status : Up
Operation Speed-duplex : 100full
Up Time : 0w 0d 1h 11m 2s (4262 seconds)
Flow Control Type : None
Max Frame Size : 1518 bytes (1522 bytes for tagged frames)
MAC Learning Status : Enabled
Console#
show interfaces
switchport
This command displays the administrative and operational status of the
specified interfaces.
SYNTAX
show interfaces switchport [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
DEFAULT SETTING
Shows all interfaces.
COMMAND MODE
Normal Exec, Privileged Exec
COMMAND USAGE
If no interface is specified, information on all interfaces is displayed.
To Next Page
Loading...
Need help?
General
