CONTENTS (CONTINUED)
Section Title Page
3.11.4 Rotational inhibit signal setting 39
3.11.5 Second speed option setting 39
3.11.6 Second speed setting 39
3.11.7 Optional output signal setting
(Emergency vent valve setting) 40
3.11.8 Second Damage Limit setting 40
3.11.9 Warning function setting 41
3.11.10 Serial port COM1 setting 42
3.11.11 Serial port COM2 setting 42
3.11.12 Date/Time setting 42
3.11.13 EdCentra setting 42
3.11.14 Factory setting 42
3.11.15 Parameter setting procedure 43
3.12 Manual operation mode 50
4 OPERATION 53
4.1 Before starting the STP pump 53
4.1.1 Confirmation before starting 53
4.1.2 Confirmation of vacuum system 53
4.2 Powering ON 54
4.2.1 Self test 54
4.2.2 "CAUTION" message in the self test state 54
4.3 How to start/stop the STP pump 55
4.4 Manual start/stop the STP pump 55
4.4.1 Starting the STP pump 55
4.4.2 Stopping the STP pump 55
4.4.3 Starting the STP pump after stopping 56
4.5 Remote operation 58
4.5.1 Input signal pins 58
4.5.2 Output signal pins 62
4.5.3 Remote setting 66
4.5.4 Starting/Stopping the STP pump 66
4.5.5 Rotation INHIBIT signal 67
4.5.6 Second speed option 68
4.5.7 Starting the STP pump after stopping 70
4.5.8 Starting the STP pump after a safety function operates 70
4.6 Powering OFF 70
4.7 Operating the TMS unit (for use with the TMS unit) 71
4.7.1 Before starting 71
4.7.2 Starting/Stopping 71
4.7.3 Setting the TMS unit function 71
4.7.4 Temperature control 71
5 SERIAL COMMUNICATION PROTOCOL 73
5.1 Introduction 73
5.2 Connection and setting up 74
5.2.1 Signal connection 74
5.2.2 Connecting the RS485 76
To Next Page
Loading...
Need help?
General
