eKey Home - Page 45

44│en Usage of the finger scanner with the control panel menu
Step
Action
Description
Display
or
The quality of the fingerprint
is acceptable. However, it
may be possible to improve
the quality by swiping the
finger again. Press OK if you
want to end the finger storing
process.
-
The quality of the fingerprint
is poor or the finger was not
recognized. Swipe the finger
over the sensor again.
-
11th
No action
required.
-
The status
LED lights
up blue.
12th
No action
required.
To store more fingers or
users, start again from step
1.
-
The fingers are stored. The system is in normal mode.
NOTICE
Testing fingers: Test the newly stored fingers on the finger scanner
immediately.
Storing an RFID transponder
NOTICE
RFID function: You can only store an RFID transponder for finger
scanners with an RFID function.
An RFID transponder is able to trigger an action on the control panel,
e.g., opening a door. You need a separate RFID transponder for each
relay. The double relay function also requires a separate RFID
transponder.
RFID transponders are stored via the main menu.
Enter the security code to access the main menu.
See Entering the security code, page 35.