DCM00044 REV. 14 73
After 6 months of normal operation:
1. Remove slide assembly from actuator.
2. Inspect the slide block and rail for damage or unusual wear.
3. Re-lubricate slide with specified grease until slide reservoir is full (minimum of 0.6 CC).
4. If slide is damaged or wear is apparent, contact your Branson Representative or Branson
Customer Service.
5. Using a setup rail (Branson #105-355); slide the block the full length of the rail 5-10 times
manually to re-circulate the rollers through the grease reservoir.
6. Re-assemble the slide assembly within the actuator.
If, after the 1st and 2nd inspections, the slide grease is abnormally low, has discoloration,
or there is dust/dirt in the slide block, more frequent inspections will be required.
To Next Page
Loading...
