Endress+Hauser Analytik Jena multi N/C 2100S User Manual

Fault removal multi N/C 2100S
94
13 No connection to the autosampler
Cause Remedy
 sample not switched on
 connection cable not connected or faulty
 switch on sampler and initialize analyzer
 check connection cable
15 no O
2
pressure at HT furnace
Cause Remedy
 O
2
–no connection present or faulty  Connect the carrier gas to HT furnace (check 4 – 6
bar preliminary pressure)
16 TC lock failure (folding head)
Cause Remedy
 The automatic lock does not open  Check the gas pressure of the auxiliary gas for the
locks (4 to 6 bar preliminary pressure required)
 Check the hose connections of the lock
20
21
22
26
no connection to optics (NDIR)
CRC error optics
status error optics
optics error; incorrect command return
Cause Remedy
 Communication errors  initialize analyzer
 NDIR detector faulty  inform Service
24 Optics error, analog values outside of range
Cause Remedy
 the analog values of the detector are outside
the working range
 check the quality of the carrier gas
 initialize analyzer and check analog values via
component test
27 Optics error, analog values outside of range
Cause Remedy
 the analog values of the detector are outside
the working range
 check quality of the carrier gas
 for solids methods and connection of HT 1300
carrier gas flow > intake flow
 initialize analyzer and check analog values via
component test
30 No connection to the N sensor
Cause Remedy
 CLD is not switched on
 connection cable not connected or faulty
 incorrect connection
 switch on CLD
 check connection cable
 check connection

Endress+Hauser Analytik Jena multi N/C 2100S Specifications

General

Brand	Endress+Hauser
Model	Analytik Jena multi N/C 2100S
Category	Measuring Instruments
Language	English