OXY5500 Optical Oxygen Analyzer BA02195C
4
–14 Endress+Hauser
If no sensor is connected or is not connected properly, and the signal cannot
be read when measurements are started, an error message will be displayed
in the status bar as shown in Figure 4–18.
The oxygen values are displayed in the following units:
• For OP-3 sensor
– %O
2
• For OP-6 sensor
– %O
2
– ppmv
Figure 4–17 Temperature sensor error message
Figure 4–18 Error message - Sensor cannot be
detected
To Next Page
Loading...
