Endress+Hauser Proline 200 - Page 20

Installation Proline Prowirl F 200 PROFIBUS PA
20 Endress+Hauser
Minimum spacing and cable length
A
L
A0019211
A Minimum spacing in all directions
L Required cable length
The following dimensions must be observed to guarantee problem-free access to the device
for service purposes:
• A =100 mm (3.94 in)
• L = L + 150 mm (5.91 in)
Rotating the electronics housing and the display
The electronics housing can be rotated continuously by 360 °° on the housing support. The
display unit can be rotated in 45 ° stages. This means you can read the display comfortably
from all directions.
Inlet and outlet runs
To attain the specified level of accuracy of the measuring device, the inlet and outlet runs
mentioned below must be maintained at the very minimum.