Endress+Hauser Proline 200 - Page 79

Proline Prowirl F 200 PROFIBUS PA Commissioning
Endress+Hauser 79
Parameter overview with brief description
Parameter Prerequisite Description Selection Factory setting
Volume flow unit – Select volume flow unit.
Effect
The selected unit applies for:
• Output
• Low flow cut off
• Simulation process variable
Unit choose list Country-specific:
• m³/h
• ft³/min
Volume unit – Select volume unit. Unit choose list Country-specific:
• m³
• ft³
Mass flow unit – Select mass flow unit.
Effect
The selected unit applies for:
• Output
• Low flow cut off
• Simulation process variable
Unit choose list Country-specific:
• kg/h
• lb/min
Mass unit – Select mass unit. Unit choose list Country-specific:
• kg
• lb
Corrected volume flow unit – Select corrected volume flow
unit.
Effect
The selected unit applies for:
Corrected volume flow
Unit choose list Country-specific:
• Nm³/h
• Sft³/h
Corrected volume unit – Select corrected volume unit. Unit choose list Country-specific:
• Nm³
• Sft³
Pressure unit For the following order code:
"Sensor version", option "Mass
flow"
Select process pressure unit.
Effect
The unit is taken from the:
• Calculated saturated steam
pressure
• Atmospheric pressure
• Maximum value
• Fixed process pressure
• Pressure
• Reference pressure
Unit choose list Country-specific:
• bar
• psi
Temperature unit – Select temperature unit.
Effect
The selected unit applies for:
• Temperature
• Maximum value
• Minimum value
• Average value
• Maximum value
• Minimum value
• Maximum value
• Minimum value
• 2nd temperature delta heat
• Fixed temperature
• Reference combustion
temperature
• Reference temperature
• Saturation temperature
Unit choose list Country-specific:
• °C
• °F