Endress+Hauser Proline 200 - Page 80

Commissioning Proline Prowirl F 200 PROFIBUS PA
80 Endress+Hauser
Parameter Prerequisite Description Selection Factory setting
Energy flow unit For the following order code:
"Sensor version", option "Mass
flow"
Select energy flow unit.
Result
The selected unit applies for:
• Outputs
• Low flow cut off
Unit choose list Country-specific:
• kW
• Btu/h
Energy unit For the following order code:
"Sensor version", option "Mass
flow"
Select energy unit. Unit choose list Country-specific:
• kWh
• Btu
Calorific value unit The following conditions are
met:
• Order code for "Sensor
version", option "Mass flow"
• The Gross calorific value
volume option or the Net
calorific value volume
option is selected in the
Calorific value type
parameter.
Select calorific value unit.
Result
The selected unit applies for:
Reference gross calorific value
Unit choose list Country-specific:
• kJ/Nm³
• Btu/Sft³
Calorific value unit (Mass) The following conditions are
met:
• Order code for "Sensor
version", option "Mass flow"
• The Gross calorific value
mass option or the Net
calorific value mass option
is selected in the Calorific
value type parameter.
Select calorific value unit. Unit choose list Country-specific:
• kJ/kg
• Btu/lb
Velocity unit – Select velocity unit.
Result
The selected unit applies for:
• Flow velocity
• Maximum value
Unit choose list Country-specific:
• m/s
• ft/s
Density unit – Select density unit.
Effect
The selected unit applies for:
• Output
• Simulation process variable
Unit choose list Country-specific:
• kg/m³
• lb/ft³
Specific volume unit For the following order code:
"Sensor version", option "Mass
flow"
Select the unit for the specific
volume.
Result
The selected unit applies for:
Specific volume
Unit choose list Country-specific:
• m³/kg
• ft
3
/lb
Dynamic viscosity unit – Select dynamic viscosity unit.
Result
The selected unit applies for:
• Dynamic viscosity
parameter (gases)
• Dynamic viscosity
parameter (liquids)
Unit choose list Pa s
Length unit – Select length unit for nominal
diameter.
Effect
The selected unit applies for:
• Inlet run
• Mating pipe diameter
Unit choose list Country-specific:
• mm
• in