Endress+Hauser Proline Promag H 300 - Page 111

Proline Promag H 300 PROFINET Commissioning
Endress+Hauser 111
Unit totalizer
→  111
Totalizer operation mode
→  111
Failure mode
→  111
Parameter overview with brief description
Parameter Description Selection Factory setting
Assign process variable Select process variable for totalizer. • Volume flow
• Mass flow
• Corrected volume flow
• Total mass flow
• Condensate mass flow
• Energy flow
• Heat flow difference
Volume flow
Unit totalizer Select the unit for the process variable of the
totalizer.
Unit choose list Country-specific:
• m³
• ft³
Totalizer operation mode Select totalizer calculation mode. • Net flow total
• Forward flow total
• Reverse flow total
• Last valid value
Net flow total
Failure mode Define the totalizer behavior in the event of
a device alarm.
• Stop
• Actual value
• Last valid value
Actual value