Endress+Hauser Proline Promag H 300 - Page 114

Commissioning Proline Promag H 300 PROFINET
114 Endress+Hauser
Parameter Prerequisite Description Selection / User
entry
Factory setting
Value 2 display A local display is provided. Select the measured value that
is shown on the local display.
• None
• Volume flow
• Mass flow
• Corrected volume
flow
• Flow velocity
• Conductivity
*
• Corrected
conductivity
*
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Current output 1
*
• Current output 2
*
• Current output 3
*
• Current output 4
*
• Temperature
• Electronic
temperature
• Noise
*
• Coil current shot
time
*
• Reference
electrode potential
against PE
*
• Coating measured
value
*
• Test point 1
• Test point 2
• Test point 3
None
Decimal places 2 A measured value is specified
in the Value 2 display
parameter.
Select the number of decimal
places for the display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx
Value 3 display A local display is provided. Select the measured value that
is shown on the local display.
• None
• Volume flow
• Mass flow
• Corrected volume
flow
• Flow velocity
• Conductivity
*
• Corrected
conductivity
*
• Totalizer 1
• Totalizer 2
• Totalizer 3
• Current output 1
*
• Current output 2
*
• Current output 3
*
• Current output 4
*
• Temperature
• Electronic
temperature
• Noise
*
• Coil current shot
time
*
• Reference
electrode potential
against PE
*
• Coating measured
value
*
• Test point 1
• Test point 2
• Test point 3
None