Endress+Hauser Proline Promag H 300 - Page 138

Operation Proline Promag H 300 PROFINET
138 Endress+Hauser
Parameter Prerequisite Description Selection / User
entry / User
interface
Factory setting
Assign channel 4 The Extended HistoROM
application package is
available.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Assign process variable to
logging channel.
Picklist, see Assign
channel 1 parameter
(→  137)
Off
Logging interval The Extended HistoROM
application package is
available.
Define the logging interval for
data logging. This value
defines the time interval
between the individual data
points in the memory.
0.1 to 3 600.0 s 1.0 s
Clear logging data The Extended HistoROM
application package is
available.
Clear the entire logging data. • Cancel
• Clear data
Cancel
Data logging – Select the data logging
method.
• Overwriting
• Not overwriting
Overwriting
Logging delay In the Data logging
parameter, the Not
overwriting option is selected.
Enter the time delay for
measured value logging.
0 to 999 h 0 h
Data logging control In the Data logging
parameter, the Not
overwriting option is selected.
Start and stop measured value
logging.
• None
• Delete + start
• Stop
None
Data logging status In the Data logging
parameter, the Not
overwriting option is selected.
Displays the measured value
logging status.
• Done
• Delay active
• Active
• Stopped
Done
Entire logging duration In the Data logging
parameter, the Not
overwriting option is selected.
Displays the total logging
duration.
Positive floating-
point number
0 s
* Visibility depends on order options or device settings