Endress+Hauser Proline Promag H 300 - Page 97

Proline Promag H 300 PROFINET Commissioning
Endress+Hauser 97
Minimum frequency value
→  98
Maximum frequency value
→  98
Measuring value at minimum
frequency
→  98
Measuring value at maximum
frequency
→  98
Failure mode
→  98
Failure frequency
→  98
Invert output signal
→  98
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Operating mode – Define the output as a pulse,
frequency or switch output.
• Pulse
• Frequency
• Switch
Pulse
Terminal number – Shows the terminal numbers
used by the PFS output
module.
• Not used
• 24-25 (I/O 2)
• 22-23 (I/O 3)
–
Signal mode – Select the signal mode for the
PFS output.
• Passive
• Active
• Passive NAMUR
Passive
Assign frequency output The Frequency option is
selected in the Operating
mode parameter (→  95).
Select process variable for
frequency output.
• Off
• Volume flow
• Mass flow
• Corrected volume
flow
• Flow velocity
• Conductivity
*
• Corrected
conductivity
*
• Temperature
*
• Electronic
temperature
• Noise
*
• Coil current shot
time
*
• Reference
electrode potential
against PE
*
• Coating measured
value
*
• Test point 1
• Test point 2
• Test point 3
Off