Multi-Function Control ETMFC610 http://www.entecene.co.kr
INTERRUPT TIME
Total, Phase A, B and C Interrupt Time : 0 to 1,000,000 sec or 0 to 65,534 sec
Momentary Interrupt Time : 0 to 1,000,000 sec or 0 to 65,534 sec
Temporary Interrupt Time : 0 to 1,000,000 sec or 0 to 65,534 sec
Sustained Interrupt Time : 0 to 1,000,000 sec or 0 to 65,534 sec
NOTE:
Depending on the “16bit Count Use” setting in the menu
“GLOBAL SETTING /
GENERAL / DEVICE / OTHERS”
, the roll-over limit of each interrupt time is
applied differently.
When the setting is OFF, each interrupt time is rolled over to 0 sec if the
interrupt time exceeds 1,000,000 sec
When the setting is ON, each interrupt time is rolled over to 0 sec if the
interrupt time exceeds 65,534
CONTACT WEAR
Phase A Wear : 0.0 to 100.0%
Phase B Wear : 0.0 to 100.0%
Phase C Wear : 0.0 to 100.0%
PEAK CURRENT
Phase A, B, C Peak Current, Ground Peak Current and Negative Sequence Peak Current
Trigger Source
Load Current Alarm Detect
ENERGY
Positive Active Power Energy – A, B, C, 3ф : 0 to 60,000 kWh or 0 to 999,999,999 kWh
Positive Reactive Power Energy – A, B, C, 3ф : 0 to 60,000 kVarh or 0 to 999,999,999 kvarh
Negative Active Power Energy – A, B, C, 3ф : 0 to 60,000 kWh or 0 to 999,999,999 kWh
Negative Reactive Power Energy – A, B, C, 3ф : 0 to 60,000 kVarh or 0 to 999,999,999 kvarh
NOTE:
Depending on the “16bit Ener’ Use” setting in the menu
“GLOBAL SETTING /
GENERAL / DEVICE / OTHERS”
, the roll-over limit of each energy value is
applied differently.
When the setting is OFF, each energy value is rolled over to 0 if the energy
value exceeds 999,999,999
When the setting is ON, each energy value is rolled over to 0 if the energy value
exceeds 60,000
To Next Page
Loading...