Multi-Function Control ETMFC610 http://www.entecene.co.kr
LOAD CURRENT ALARM EVENT RECORDER
Trigger Source
Phase A, B, C Load Current Alarm
S.E.F Load Current Alarm
Negative Sequence Load Current Alarm
Trigger type : Pick up
Storage Capacity : Last 1,500 Events
NOTE :
The maximum number of all events except fault waveform to be stored can be
increased according to user requests.
COUNTER
System Restart Counter : 0 to 1,000,000 or 0 to 65,534
Diagnostic Counter : 0 to 1,000,000 or 0 to 65,534
Operation Counter : 0 to 1,000,000 or 0 to 65,534
Fault Counters : 0 to 1,000,000 or 0 to 65,534
PQM Counters : 0 to 1,000,000 or 0 to 65,534
Communication Counter : 0 to 1,000,000 or 0 to 65,534
User Counter : 0 to 1,000,000 or 0 to 65,534
NOTE:
Depending on the “16bit Count Use” setting in the menu
“GLOBAL SETTING /
GENERAL / DEVICE / OTHERS”
, the roll-over limit of each counter is applied
differently.
When the setting is OFF, each counter is rolled over to 0 if the counter value
exceeds 1,000,000
When the setting is ON, each counter is rolled over to 0 if the counter value
exceeds 65,534
To Next Page
Loading...