Entec ETMFC610 - Page 90

Multi-Function Control ETMFC610 http://www.entecene.co.kr
80
EN
HANCED
TEC
HNOLOGY
GLOBAL SETTING / GENERAL / MONITORING / CONTACT WEAR / A Wear Set
Range
0.00 ~ 100.00 %
Default
100.00
Step
0.01%
It is to set switch (or CB) phase A contact wear value in ETMFC610
.
Set value is available after Contact Wear Reset. Contact wear reset
refers to “MAIN MENU/ MAINENANCE/ DATA RESET/ CONTACT
WEAR or COUNT ALL” menu.
GLOBAL SETTING / GENERAL / MONITORING / CONTACT WEAR / B Wear Set
Range
0.00 ~ 100.00 %
Default
100.00
Step
0.01%
It is to set switch (or CB) phase B contact wear value in ETMFC610
.
Set value is available after Contact Wear Reset. Contact wear reset
refers to “MAIN MENU/ MAINENANCE/ DATA RESET/
CONTACT WEAR or COUNT ALL” menu.
GLOBAL SETTING / GENERAL / MONITORING / CONTACT WEAR / C Wear Set
Range
0.00 ~ 100.00 %
Default
100.00
Step
0.01%
It is to set switch (or CB) phase C contact wear value in ETMFC610
.
Set value is available after Contact Wear Reset. Contact wear reset
refers to “MAIN MENU/ MAINENANCE/ DATA RESET/
CONTACT WEAR or COUNT ALL” menu.
NOTE :
1. Password 3 authentication is required when entering “MENU/ MAINENANCE/ DATA
RESET” menu to reset “Phase A Contact Wear”, “Phase B Contact Wear” and “Phase C
Contact Wear”.
2. Current contact wear of each phase can be checked in “MENU/ MAINENANCE/
CONTACT WEAR” menu.
[CONTACT WEAR]
>Interrupt I2: 20.0
>Interrpt Ct2: 16
>A Wear Set: 100.00
>B Wear Set: 100.00
>C Wear Set: 100.00
[0.00~100.00:0.01%]
[CONTACT WEAR]
>Interrupt I2: 20.0
>Interrpt Ct2: 16
>A Wear Set: 100.00
>B Wear Set: 100.00
C Wear Set: 100.00
[0.00~100.00:0.01%]
[CONTACT WEAR]
>Interrupt I2: 20.0
>Interrpt Ct2: 16
>A Wear Set: 100.00
>B Wear Set: 100.00
>C Wear Set: 100.00
[0.00~100.00:0.01%]