Entec EVRC2A-N6-NT - Page 4

RECLOSER CONTROL EVRC2A-N6,NT http://www.entecene.co.kr
ii
ENHANCED TECHNOLOGY
[Mar. 2011] Ver5.20
1. Add “Loss of Phase” in “PROTECTION” menu according to an additional function (option),
“Loss of Phase”.
2. Add “Supply Outage Measurement” as an additional function in menu.
- Add “S-Outage” and “S-O Dura” set-up in “RELAY SETUP/ EVENT RECORDER” menu.
- Add “S-Outage Count” and “S-Outage Event” set-up in “RELAY SETUP/ CLEAR SAVED
DATA” menu.
- Add “S-OUTAGE COUNTER” in “MAINTENANCE” menu.
- Add “SUPPLY OUTAGE” in “EVENT RECORDER” menu.
[Jan. 2012] Ver6.00
After the Ver6.00, the manual is applied to the
“EVRC2A-N6(Network type)” .
[Jan. 2012] Ver6.00
1. Change the terms related with battery testing.
[Feb. 2012] Ver6.01
1. Add “Power Quality” set-up in “SYSTEM SETUP” menu.
2. Change “Supply Outage” to “Power Quality” in some menus.
- Change “S-Outage Counter” to “Power Quality” in “MAINTENANCE” menu.
- Change “Supply Outage” to “Power Quality” in “EVENT RECORDER” menu.
- Change “S-Outage Count” and “S-Outage Event” to “P-Quality Count” and “P-Quality” in
“RELAY SETUP/ CLEAR SAVED DATA” menu.
3. Add “HARMONICS” in “MAIN MENU/6.METERING” menu.
[Jun. 2012] Ver6.02
Changed the manual based on EVRC2A-N6 firmware V6.12 upgrading.
1. Section to be rectified in the manual as a result of adding measuring function of
voltage/current unbalance.
- Change “METERING” in “1.2. Summary of Features”.
- Change “Table 2-1. Metering Accuracy” in “2.3. Metering Accuracy”.
- Add “10.1.9. Unbalance”.
- Change “Table 10-1. Metering Accuracy” in “10.2. Accuracy”.
2. Section to be rectified in the manual as a result of adding detection function of
voltage/current unbalance.
- Change “MONITORING” in “1.2. Summary of Features”.